Important KSC article MBD & PMI Test part

Category: Geen categorie

Gear knowledge

Van Eijk transmission was the first company that dared to investigate their internal knowledge to see if it strengthens them as a company. We as KSC are proud to be…
Read more

Kennis borgen en delen

Storing knowledge must be done before you can start the knowledge sharing process. The KSC needs limits on manufacturing processes to reduce the bridge between designer and manufacturing companies. But…
Read more

Presence Precision fair 2018

This trade fair presence was all about discussion about sharing knowledge. In collaboration with HVL Metaalbewerking, we had set up a picnic table where we invited people to talk together…
Read more

Meeting November 31, Rabobank Utrecht

Rabobank hosted a special new initiative in the manufacturing industry. Active knowledge sharing between OEMs, manufacturing companies, engineering companies and knowledge institutes is necessary to increase the effectiveness of the…
Read more

KSC Event 25 Mei 2018

The KSC, together with Rabobank Zuid, has organized an event where knowledge sharing was an important item. During this event we will be guest at Craft Education and De Metaalzaak…
Read more

Roadshow Verspanen

Together with the Mikrocentrum we organized a meeting about clean machining. "The importance of PMI and clean machining for ASML." PMI: Product and manufacturing information (PMI) is used in 3D…
Read more

Knowledge sharing Evening 12 December 2017

Innovate and collaborate by sharing knowledge. During this evening we were guests at 'Van Eijk Transmissie' in Asten. We would like to thank 'Van Eijk Transmissie' for their hospitality and…
Read more

Using a VR movie

Present your organization by use a VR movie. As a trial, the Knowledge Sharing Center, together with the Peelpioneers, converted the Van Eijk Transmission factory into a VR movie. A…
Read more

Groot worden zonder groeien.

Getting big without growing. This book is an appeal to companies to compete from sharing knowledge. Collaboration will only become more important in the future. Knowledge Sharing Centre is mentioned…
Read more

Precision Fair 2017

Knowledge Sharing Centre was present at the precision fair. Stand 214 (Dommelhal) Thanks to the Mikrocentrum we could present ourselves at the precision fair at the Koningshof Veldhoven. We had…
Read more
KSC Wheel

Why a Knowledge Sharing Centre?

Things are running rather smoothly in the high tech manufacturing industry. Even so, this is no guarantee for the future. Collaboration based on knowledge sharing will brings us the new future.

The KSC is the connector between companies from the design and manufacturing industry, which bundles knowledge in an accessible way to achieve joint growth and collaborations on a trusted basis.

Read more

Also visit our other websites

X